Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

86 Chapter5
Configuring Serial Devices (for Host-Based Management)
Modify the Network Management Configuration File
CAUTION Before you exit this screen, make sure you press [Save Data] if you want
to keep the data on the screen; otherwise your screen input will be lost.
This occurs even if you temporarily exit the screen to read
[Help]
information.
7. To configure another card, enter the card number you want to
configure in the field “To configure a different card, enter
its number,...” . The desired card number must have already
been configured in the previous section, “Step 6: Specify DTC
Configuration.” The card is configured if a valid card type is entered
in the “Type” field on the previous DTC configuration screen.
8. Press the
[Config Card] function key. The corresponding screen for
the card number entered in the last step will be displayed.
9. If all the cards have been configured, press the [Prior Screen] function
key to return to the DTC Configuration Selection screen to select
another DTC to configure. Otherwise, if every DTC has been
configured, press the
[Validate DTS/LINK] function key to validate the
configuration file.
NOTE NMMGR allows the configuration of up to 4649 terminal I/O devices.
The largest valid ldev number allowed is 4679.