Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

84 Chapter5
Configuring Serial Devices (for Host-Based Management)
Modify the Network Management Configuration File
Config SNMP You may use the [Config SNMP] key on the DTC Screen
to configure the DTC to act as an SNMP agent. This
key goes to a screen to configure the DTC to act as an
SNMP agent. Refer to Appendix C, “DTC User
Interface,” for steps to do this. Refer to the DTC
Technical Reference Guidemanualfor more information
on SNMP.
Step 7: Configure DTC Cards
When you press the [Config Card] key at the DTC Configuration screen,
NMMGR will display the corresponding card configuration screen for
the specified card in the DTC. Figure 5-6 shows an example of a Card
Configuration screen for DTC 72MX for asynchronous connect card.
(Screens vary slightly for DTC 16iX/16MX/16RX, DTC 16, and DTC 48).
The corresponding screen for a DTC 16iX/16MX/16RX is called a Port
Configuration Screen since DTC 16iX/16MX/16RX has port connectors
built directly onto the backplane and does not have connector cards.
Use this screen to configure the ports in the specified card. On this
screen, logical device (ldev) numbers and profile names are associated
with individual ports on the card.
Figure 5-6 DTC Card Configuration Screen
1. Verify that the DTC name and card number displayed are correct.
2. (Optional) Enter the port group type. The valid types are D for direct
connect and M for modem connect. The default is D.