Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 5 73
Configuring Serial Devices (for Host-Based Management)
Copy the Sample File
Copy the Sample File
Network information is stored in a configuration file called
NMCONFIG.PUB.SYS. If you do not already have a NMCONFIG.PUB.SYS
file, create a copy of NMCONFIG.PUB.SYS from the sample configuration
file supplied on the HP 3000, NMSAMP1.PUB.SYS.
To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these
commands at the MPE/iX prompt (:):
NOTE “DEV=1” must be specified in the FILE equation to specify that the
NMCONFIG.PUB.SYS file is to be stored to system disk 1.
HELLO MANAGER.SYS,PUB
FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1
FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW