Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

166 Chapter8

Additional DTC Conﬁguration

Conﬁguring SNMP

This section describes how to conﬁgure a host-managed DTC to act as

an SNMP (Simple Network Management Protocol) agent. For PC-based

DTC management, refer to the Using HP OpenView DTC Manager

manual.

Conﬁguring SNMP Authorization Filters

To conﬁgure SNMP authorization ﬁlters, access the SNMP

Authorization Filter Conﬁguration screen within NMMGR. This screen

can be accessed by pressing

[F4], the [Conﬁg SNMP] function key at the

DTC Conﬁguration screen. See the beginning of this chapter to ﬁnd out

how to access the

[Conﬁg SNMP] function key. (Refer to Figure 5-5 for an

example of a DTC Conﬁguration screen for a DTC 72MX.) The screen

can also be accessed by pressing the

[Go To Filter] key at the SNMP MIB

Conﬁguration screen or the SNMP Trap Destination Conﬁguration

screen.

The SNMP Authorization Filter Conﬁguration screen for host-based

management is shown below, in Figure 8-4. You can conﬁgure

authorization ﬁlters for up to ﬁve SNMP managers.

Figure 8-4 SNMP Authorization Filter Screen

The “DTC Name” ﬁeld is a read-only ﬁeld which indicates the SNMP

conﬁguration is for that speciﬁc DTC.