Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 7 121
Terminal and Printer Profiles
Terminal Profile Screen (Host-Based)
Terminal type
file name Instead of using the default terminal types 10, 18, or
24, you may create your own terminal type and save it
in a file. To create a customized terminal type, use the
Workstation Configurator, TTUTIL.PUB.SYS. Refer to
the Customizing Terminal and Printer Type Files with
Workstation Configurator for more information.
Line speed The line speed, in bits per second. Supported speeds are
300, 1200, 2400, 4800, 9600, 19200, and 38400. (Line
speed 38400 is supported for direct connect devices on
DTC 16iX/16MX and DTC 72MX only, and the attached
device must also support this speed. This field does not
apply for DTC 16RX access to an HP 3000 in an
MPE/iX host-based management environment; any
value entered in this field for a DTC 16RX will be
ignored.)
Record
width The number of characters for each record. For HP
terminals, the record width is usually 80 (the width of
the screen).
Modem type Specifies the type of modem used in the connection.
0 means that modems will not be used.
1 means that a US modem will be used.
2 means that a European modem will be used.
3 means that a Five wires modem will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
4 means that a US In Out modem will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
5 means that a European Modem In Out will be used.
(Supported on DTC 16iX/DTC 16MX and DTC 72MX
only.)
Modem
behavior The DTC supports the following types of modem
behavior which define the protocol used to establish a
modem link between the DTC port and the attached
device.
0 means no modem used.