Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

106 Chapter6
Configuring Serial Devices (for PC-Based Management)
Modify the Network Management Configuration File
3. After successful validation and cross-validation, and if the file in use
is NMCONFIG.PUB.SYS, the following prompt will appear:
Answer Y if you want to invoke DTCCNTRL and make DTS changes
take effect now, or answer N if you don't want DTS changes to take
effect now. Note any messages that describe additional actions
needed for changes to become active. After you exit NMMGR you can
review any actions needed by viewing the logs at the end of the file
LOGDCC.PUB.SYS.
If you answer N, the DTS changes will take effect the next time
DTCCNTRL is invoked, a DTS shutdown/restart is done, or the
system is rebooted.
Type H if you need more help to answer the question. See Chapter 4,
“Dynamic Configuration and DTS Shutdown/Restart,” for more
information on dynamic configuration.
4. After viewing the messages describing what actions are required, if
any, enter
[RETURN] when you see the prompt:
(Press RETURN when finished viewing screen contents.)
You will return to the Validation screen. You may make additional
configuration changes or exit NMMGR.
Do you want DTS changes to be become active now (Y/N)?
Y = all changes made take effect now
N = all changes made will take effect upon next
dynamic configuration or system boot
H = help
>