Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 6 103

Conﬁguring Serial Devices (for PC-Based Management)

Modify the Network Management Conﬁguration File

6. If all the cards with nailed ports have been conﬁgured, press the

[Prior Screen] key to return to the DTC Conﬁguration Selection

screen to select another DTC with nailed ports to conﬁgure.

Otherwise, if every DTC has been conﬁgured, press the

[Validate DTS/LINK] key to validate the conﬁguration ﬁle.

Conﬁgure a X.25 Card

When a X.25 card is conﬁgured using PC-based management, you can

use the screen in Figure 6-7 to conﬁgure nailed PAD devices. The screen

is only available for a DTC 48, DTC 16 and DTC 72MX.

NOTE

Also refer to Using HP OpenView DTC Manager for all other X.25 and

PAD conﬁguration information.

Figure 6-7 DTC X.25 Card Conﬁguration Screen

1. Verify that the “DTC name” and “Card number” displayed are

correct.

2. Use the

[TAB] key to move the cursor to the desired ﬁelds. Enter the

ldev number, proﬁle and device name in the ﬁelds on the screen for

nailed device.

Ldev numbers used for each port on all DTCs must be unique. Up to

4649 terminal I/O devices may be conﬁgured on the HP 3000

Series 900. The largest valid ldev number is 4679.