Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
DCC Error Messages
Appendix B
202
Cause: A problem exists with the datacomm buffers.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 8) DCC ERROR P-L, (External procedure not found, status SSSSSSSS).
Cause: A problem exists with DCC execution.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 9) DCC ERROR P-L, (Memory management error status SSSSSSSS).
Cause: A problem with the system occurred; the DCC cannot obtain memory.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 10) DCC ERROR P-L, (Ports status SSSSSSSS).
Cause: A problem with the DCC or the port's subsystem occurred.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 11) DCC ERROR P-L, time out on reply msg, descriptors MMM.
Cause: The DCC did not receive a reply message within the allotted time.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 12) DCC ERROR P-L, too many DTCs configured.
Cause: The NMCONFIG.PUB.SYS file contains more than the supported number of DTCs.
Action: Delete the excess DTCs from the NMCONFIG.PUB.SYS file and restart DTS.
(DCCERR 13) DCC ERROR P-L, link name specified for the DTS does not exist.
Cause: The link name configured in NMMGR on the DTS Configuration screen does not
exist.
Action: Go to the DTS Configuration screen and enter the link name, then restart DTS.
(DCCERR 14) DCC ERROR P-L, link name specified for the DTS is not available (link status
SSSSSSSS).
Cause: A problem occurred with the link hardware; the LANIC might be in the wrong
slot or it might not be connected to the LAN.
Action: Check the hardware configuration and connections, then restart DTS.
(DCCERR 15) DCC ERROR P-L, too many links configured.
Cause: More that eight links are configured.
Action: Delete all unused links so that eight or less links are used, then restart DTS.
(DCCERR 16) DCC ERROR P-L, message received on wrong subque.
Cause: A problem exists with the interprocess communication.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 17) DCC ERROR P-L, unrecognized message received.
Cause: A problem exists with the interprocess communication.
Action: Contact your Hewlett-Packard support representative.
(DCCERR 18) DCC ERROR P-L, internal DCC logic error.
Cause: A problem internal to the DCC exists.