Configuring and Managing Host-Based X.25 Links - Edition 6 (36939-90057)

Error Messages
Validation Error Messages
Appendix B
199
Cause: Eight bit data length with odd/even parity (“8odd” or “8even”) feature is not
supported on DTC 16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the entry for the parity to the
required value other than “8odd” or “8even”.
(DTSERR 94) Path: NMMGRpath — Two stop bits for LDEV#nnn, defined in Profile <profilename>, is
not supported on DTC 16 or DTC 48.
Cause: Modem Two stop bits feature is not supported on DTC16 or DTC 48.
Action: Go to DTC specified in NMMGRpath and change the.entry for the stop bts to
one.
(DTSERR 95) Path: NMMGRpath — Binary port config for LDEV#nnn, defined in Profile
<profilename>, is not supported on DTC 16 or DTC 48.
Cause: Modem The feature for forcing data length and parity when binary mode is
selected is not supported on DTC 16 or DTC 48.
Action: Go to DTC specified in NMMGRpath and change the. entry for the binary port
config filed to “N”.
(DTSERR 98) Path: NMMGRpath — Duplicate IP address or Node name found on card n.
Cause: Two entries on the screen specified by NMMGRpath have the same IP address
configured on the specified card.
Action: Go to specified screen and change one of the entries.
(DTSERR 100) Path: NMMGRpath — Invalid IP address found on card n for X.25 address xxxxx.
Cause: The format of the IP address for the entry on the screen specified by
NMMGRpath with the specified X.25 address is invalid.
Action: Go to specified screen and fix the format of the entry.
(DTSERR 101) Path: NMMGRpath — Invalid IP address or Node name found on card n for X.25
address xxxxx.
Cause: The format of the IP address for the entry on the screen specified by the
NMMGRpath with the specified X.25 address could not be determined to be a valid IP
address of NS or ARPA Node Name format.
Action: Go to specified screen and fix the format of the entry.
(DTSERR 102) Path: NMMGRpath — Too many Sys-to-Sys LUG entries found. Maximum is 256.
Cause: The X.25 table in the DTC specified in NMMGRpath cannot be processed. Too
many System-to-System Local User Group entries are already configured.
Action: Go to DTC configuration screen and delete the entries until only the specified
number remain in NMMGRpath.
(DTSERR 103) Path: NMMGRpath — Too many Sys-to-Sys Switching table entries found. Maximum is
32.
Cause: The X.25 table in the DTC specified in NMMGRpath cannot be processed. Too
many System-to-System Switching entries are already configured.
Action: Go to DTC configuration screen and delete the entries until only the specified
number remain in NMMGRpath.
(DTSERR 104) Path: NMMGRpath — Too many PAD Switching table entries found. Maximum is 32.