Communicator e3000 MPE/iX Release 7.5 (Software Release C.75.00) (30216-90336)

Chapter 4
Fibre Channel Device and Adapter Support on HP e 3000 Systems
FCSCAN — Fibre Channel Device Scan Utility
52
io> lp 0/8/0/0.0.1
PATH: 0/8/0/0.0.1 LDEV: 60
ID: HPDARRAY TYPE: DISC
PMGR: SCSI_DISK_AND_ARRAY_DM PMGRPRI: 8
LMGR: LOGICAL_DEVICE_MANAGER MAXIOS: 0
io> lp 0/8/0/0.0.105
PATH: 0/8/0/0.0.105 LDEV: 60
ID: HPDARRAY TYPE: DISC
PMGR: SCSI_DISK_AND_ARRAY_DM PMGRPRI: 8
LMGR: LOGICAL_DEVICE_MANAGER MAXIOS: 0
NOTE For FCSCAN to be able to scan for devices under an FC card, the adapter card at this hardware
path should have already been configured through SYSGEN. If the card is not configured in the
system, FCSCAN will not recognize the card.
If FCSCAN output shows only the adapter card but no devices under it, then it is most likely
that the device has not been connected properly. Verify the FC cable connecting the FC device
to the adapter. Try again running FCSCAN with “-h” option.
FCSCAN Output with “-n” Option
The option “-n” specifies FCSCAN to print only the FC adapter cards and FC device N_Ports on the system. It
does not print individual LUNs under the FC devices. This is a shorter version to easily know what FC
devices are connected to each FC adapter card.
:fcscan -n
FCSCAN has found the following Fibre Channel I/O Adapter Cards and N-Ports on this system.
SYSGEN PATH DESCRIPTION
============= =============
0/2/0/0 Fibre Channel Adapter
0/8/0/0 Fibre Channel Adapter
0/8/0/0.0 XP512 controller
0/8/0/0.24 SEAGATE ST39103FC disk
0/8/0/0.25 SEAGATE ST39103FC disk
0/8/0/0.26 SEAGATE ST39103FC disk
0/8/0/0.27 SEAGATE ST39103FC disk
0/8/0/0.34 HP A5236A controller
The above output indicates that there are two FC cards in the system at hardware paths 0/2/0/0 and 0/8/0/0.
There is no device connected under card 0/2/0/0. Under card 0/8/0/0, there are some FC device N_Ports
available. The description column in the output specifies what kind of device each N_Port belongs to. Note