APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

80 Chapter4
APPC Subsystem Configuration
Configuring the APPC Subsystem
APPC: Network ID Data Screen
The “APPC: Network ID Data” screen, shown in Figure 4-5, is where
you configure the name of the local SNA network. Configure the
network ID only if your HP 3000 will operate as a Node Type 2.1 in a
peer-to-peer environment.
When you have finished entering the network ID, press
[f6] (Save
Data), and then press
[f8] (Prior Screen) to return to the “APPC
Configuration” screen.
Figure 4-5 APPC: Network ID Data Screen
Fields
Local Network ID
Required. Enter the network ID of the local SNA
network. For AS/400 communication, the Local
Network ID should match the RMTNETID in the
Controller Description of the AS/400 configuration. If
the RMTNETID on the AS/400 is specified as *NETATTR,
the Local Network ID in this screen must match the
Local network ID in the AS/400 Network Attributes
Table.