APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Chapter 4 79
APPC Subsystem Configuration
Configuring the APPC Subsystem
APPC Configuration Screen
The “APPC Configuration” screen, shown in Figure 4-4, allows you to
choose among the four branches of the APPC subsystem configuration:
Network ID, Session Types, Mode Types, and TPs.
Figure 4-4 APPC Configuration Screen
The network ID must be configured only if the HP 3000 will operate as
a Node Type 2.1 in a peer-to-peer environment. Press
[f1] (Go To NET
ID) to get to the “APPC: Network ID Data” screen.
To configure session types, press [f2] (Go To SESSION) to get to the
“APPC: Select Session Type” screen.
To configure mode types, press [f3] (Go To MODE) to get to the “APPC:
Select Mode Type” screen.
To configure remotely initiated local TPs, press [f4] (Go To TP) to get to
the “APPC: Select Transaction Program” screen.