APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

74 Chapter4

APPC Subsystem Conﬁguration

NMMGR Conﬁguration Overview

Use NMMGR to create or modify an APPC subsystem conﬁguration.

The NMMGR utility is described in Using the Node Management

Services Utilities; if you are not familiar with NMMGR, you should read

that manual before continuing.

You conﬁgure the APPC subsystem by deﬁning the network in which it

will operate, the nodes and LUs that will communicate over APPC

sessions and the properties of the APPC sessions. Table 4-3 lists the

NMMGR screens used to conﬁgure the APPC subsystem, and it gives

the page number in this chapter where each screen is described.

Figure 4-1 is a map of the NMMGR screens you use to conﬁgure the

APPC subsystem.

Table 4-3 NMMGR Screen Index

Main Figure 4-2 on page 77

HP-IBM Conﬁguration Figure 4-3 on page 78

APPC Conﬁguration Figure 4-4 on page 79

APPC: Network ID Data Figure 4-5 on page 80

APPC: Select Session Type Figure 4-6 on page 81

APPC: Independent LU Session Type Data Figure 4-7 on page 83

APPC: Dependent LU Session Type Data Figure 4-9 on page 88

APPC: Dependent LU List Data Figure 4-10 on page 91

APPC: Select Mode Type Figure 4-11 on page 92

APPC: Mode Type Data Figure 4-12 on page 94

APPC: Select Transaction Program Figure 4-13 on page 95

APPC: Transaction Program Data Figure 4-15 on page 98