APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

52 Chapter2
Interactive Control Operator Commands
APPCCONTROL STOPSESSION
APPCCONTROL STOPSESSION
Terminates the session with the specified Session ID .
Syntax
APPCCONTROL STOPSESS[ION]
;SID= Session ID
Parameters
Session ID Required. The unique session identification number of
the session you want to terminate. You can obtain the
Session ID by issuing the APPCCONTROL STATUS
command.
Description
The APPCCONTROL STOPSESSION command is used to terminate a single
APPC session. It does not alter the current session limit for the session
type.
Use the APPCCONTROL STOPSESSION command to kill APPC sessions
that could not be terminated with the APPCCONTROL SESSIONS
command.
The APPCCONTROL STOPSESSION command does not provide a
StopType
parameter; the StopType is always KILL, meaning that the session will
be terminated immediately, along with any conversation being
conducted over the session. If you want to terminate a session with a
StopType of PROTOCOL or QUIESCE, try using the APPCCONTROL
SESSIONS command to reduce the current session limit for the session
type. Use the APPCCONTROL STOPSESSION command only if the
APPCCONTROL SESSIONS command fails to terminate an APPC session.
This command terminates APPC sessions only; it cannot be used to
terminate LU-LU sessions being used with other SNA Services.
NOTE This command will not terminate any transaction programs. Users
must terminate any transaction programs that are still active after
their sessions have been terminated.