APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

48 Chapter2
Interactive Control Operator Commands
APPCCONTROL STATUS
Session ID
The unique identification number given to each session
activated for the session type.
LFSID
Local Form Session Identifier. This number identifies
the session to the SNA link product. The SNACONTROL
STATUS command, which displays the status of the
SNA link product, identifies each LU-LU session by
LFSID. For more information on the SNACONTROL
STATUS command, see the SNA Link/XL Node
Manager’s Guide.
State
The state of a session. Each of the possible states is
described below:
NO SESS. No APPC sessions are active or being
activated for this session type. The
session type’s session limit has been set
to 0.
WAITING The APPC session is waiting for
activation. No response has been
received from the remote system or
from SNA Transport.
PENDING Activation of the APPC session is
pending. Activation is proceeding but is
not complete.
ACTIVE The APPC session is ready for
conversation.
TERM The APPC session is in termination
state.
ERROR The APPC session is in an error state.
You should bring down the APPC
subsystem.
LU Type
Whether the local LU is the primary or secondary LU
for the session. LU Types are as follows:
PRI Primary LU. The local LU sends the
BIND to initiate the session.
SEC Secondary LU. The local LU receives
the BIND from the remote LU.