APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Chapter 2 47
Interactive Control Operator Commands
APPCCONTROL STATUS
Reading the Display
Each of the columns in the example status display is described below:
Number of Active Sessions
The current number of active or pending sessions for
the session type. This number should be equal to the
configured Automatically Activated Sessions
value at subsystem startup, or, if you have issued the
APPCCONTROL SESSIONS command to raise the session
limit, it should be equal to the number you specified in
the command. However, for independent LU session
types running parallel sessions, the number of active
sessions might be negotiated down from the number
you specified.
Number of Queued Session Requests
The number of outstanding session requests for the
session type. Session requests are queued when TPs
call the MCAllocate or MCGetAllocate intrinsic and
no sessions are immediately available.
Local LU
The name of a local LU associated with the session
type.
SNA Node
The name of the SNA node configured for the session
type.
Remote LU
The name of the destination LU on the remote system.
Mode
The mode configured for the session type. See Chapter
4 , “APPC Subsystem Configuration,” of this manual for
more information on mode configuration.
Session Limits
The maximum number of sessions for the session type.
Maximum The configured maximum number of
sessions for the session type.
Current The current maximum number of
sessions. This number will be equal to
the number of active sessions, unless
the remote system has some sessions
configured as contention winners
(controlled by the remote LU).