APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

44 Chapter2
Interactive Control Operator Commands
APPCCONTROL STATUS
If you want to print the output from the APPCCONTROL STATUS
command, you can redirect the output to a disk file and then print the
file. Redirecting the output creates a temporary file, so you must save
the file to disk before you can print it. The following commands redirect
the output from the APPCCONTROL STATUS command to the file outfile
and then save outfile to disk:
:APPCCONTROL STATUS > outfile
:SAVE outfile
Examples
In the following example, the APPCCONTROL STATUS command was
issued with no parameters. The status display includes all configured
session types and all active TPs.
:APPCCONTROL STATUS
Internal Trace File : NMTC0020.PUB.SYS
Performance Tracing : ON
--------------------------------------------------
Number of Active Sessions for APPC Subsystem : 5
--------------------------------------------------
Session Type Information :
---------------------------------------
Independent LU Session Type : STYPE1
---------------------------------------
Number of Active Sessions : 4
Number of Queued Session Requests : 3
Session Limits
Local LU SNA Node Remote LU Mode Maximum Current
-------- -------- ----------------- ------ ------- -------
INDLU1 SNANODE NET1.IBMLUA MODE1 50 50
Session ID LFSID State LU Type TP ID
---------- ----- ------ ------- -----
62 0103 1 ACTIVE PRI 1011
75 0104 1 ACTIVE PRI 6712
11 0106 1 ACTIVE SEC 1788
98 0105 1 ACTIVE SEC 1219