APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

242 AppendixD

LU 6.2 API/XL Installation Guidelines

HP 3000 Requirements

This section describes the HP 3000 operating environment that

supports LU 6.2 API/XL.

Hardware

The following hardware is required to run LU 6.2 API/XL:

• A 900 Series HP 3000.

• An HP 30263A Programmable Serial Interface (PSI) card and the

appropriate PSI cables. The PSI is bundled with SNA/SDLC

Link/XL or SNA/X.25 Link/XL. One PSI is required for each link to a

remote system.

• A full or half duplex data communication line (switched or leased)

between the HP 3000 and the remote system.

• A pair of modems for the communication line. Only full-duplex,

synchronous modems are supported.

• A block-mode terminal which is supported by VPLUS/3000 for Node

Management Services conﬁguration.

Software

The following software is required to run LU 6.2 API/XL on the

HP 3000:

• LU 6.2 API/XL, version B.00.00 or later.

• The HP 3000 Multi-Programming Executive (MPE XL) operating

system (release 4.0 or later).

• SNA/SDLC Link/XL or SNA/X.25 Link/XL bundled hardware and

software product, version B.00.10 or later.

• Node Management Services (NMS) version B.03.00 or later.