APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix C 231
Configuration Worksheets
Completing the Worksheets
SNA Node Name field. The number of dependent LUs must match
the number in the Maximum Number of Sessions field.
You can list the same LUs for more than one session type, but you
must make sure you have enough LUs to accommodate all the
sessions, of all types, that will be active at once. A dependent LU can
carry on only one session at a time.
7. For each session type, determine the number of sessions that will be
activated when the APPC subsystem is started, and write the
number in the Automatically Activated Sessions field. The
Automatically Activated Sessions value must be less than or
equal to the Maximum Number of Sessions value.
When you have completed the Dependent LU Session Types
worksheet, add up all the Automatically Activated Sessions for
all the dependent and independent LU session types. If the sum is
greater than 256, adjust the Automatically Activated Sessions
values until the sum is less than or equal to 256. The sum of all the
Automatically Activated Sessions, for all independent and
dependent LU session types, must be less than or equal to 256.
Completing the Mode Types Worksheet
Follow these steps to complete the Mode Types worksheet:
1. Write each different Mode Name from your Independent LU Session
Types worksheet and Dependent LU Session Types worksheet in a
separate Mode Name field on the Mode Types worksheet.
2. Under each Mode Name, write the Maximum Size of RU to Send
and the Maximum Size of RU to Receive. These values must
match the values configured for the remote LU.
For IBM mainframe communication, these values must match the
values configured in the RUSIZES parameter of the MODEENT
Logmode Table macro. For AS/400 communication, these values
must match the MAXLENRU value in the Mode Description on the
AS/400.
3. For each mode type, write the Maximum Size of Send Pacing
Window and the Maximum Size of Receive Pacing Window.
These values must match the values configured for the remote LU.
For IBM mainframe communication, these values must match the
SRCVPAC and SSNDPAC parameters of the MODEENT Logmode Table
macro. For AS/400 configuration, these values must match the
INPACING and OUTPACING values configured in the Mode Description
on the AS/400.