APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 181
Messages
Configuration Messages
24 MESSAGE: Path : APPC.SESSION.!
LU “!” is not an independent LU under SNANODE.! screen.
(APPCVALERR 24)
CAUSE: You have configured an independent LU session type to use a
local LU that is not configured as an independent LU on the SNA node
you specified for the session type.
ACTION: Specify an LU that is configured as an independent LU on the
correct SNA Node. (Independent LUs must have no LU# configured in
the “SNA Node Configuration: LU Data” screen.)
25 MESSAGE: Path : APPC.SESSION.!
Number of LUs in LULIST (!) does not equal the Maximum Number of
Sessions (!). (APPCVALERR 25)
CAUSE: You have configured more or fewer dependent LUs than you can
have sessions of the specified session type.
ACTION: Delete some dependent LUs from the LU list, or add some
dependent LUs to the LU list, until the number of LUs equals the
Maximum Number of Sessions configured for that session type. Or
change the Maximum Number of Sessions value to match the number
of LUs configured.
26 MESSAGE: Path : APPC.SESSION.!
“!” is not a correctly formatted Remote LU Name. (APPCVALERR 26)
CAUSE: You have specified a Remote LU Name that does not have the
correct format.
ACTION: Specify the Remote LU Name as
netid.luname , where netid is
the network identifier for the remote system, and
luname is the name of
the remote LU.
27 MESSAGE: Path : APPC.TP.!
There is no Transaction Program Data configured. (APPCVALERR 27)
CAUSE: A transaction program name was configured in the APPC:
Select Transaction Program screen, but no data was configured for it in
the APPC: Transaction Program Data screen.
ACTION: Configure the data for the specified transaction program.
28 MESSAGE: Path : APPC.TP.!
“!” is not a correctly formatted job name. (APPCVALERR 28)
CAUSE: You have specified a Job Name that does not have the correct
format.
ACTION: Specify the Job Name as file.group.account . The file must
not contain any lockwords.