APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

180 AppendixA
Messages
Configuration Messages
ACTION: Configure the Mode Name in the APPC: Select Mode Type
screen and the APPC: Mode Type Data screen.
19 MESSAGE: Path : APPC.SESSION.!
SNA Node “!” does not support dependent LUs. (APPCVALERR 19)
CAUSE: You have configured a dependent LU session type to use a
Type 2.1 SNA node without dependent LU support.
ACTION: Specify Node 2.1 Dependent LU Support = Y in the “SNA
Node Configuration: PU Data” screen for that node, or specify a
different SNA node for the session type.
20 MESSAGE: Path : APPC.SESSION.!
SNA Node “!” is not a PU 2.1 type node. (APPCVALERR 19)
CAUSE: You have configured an independent LU session type to use a
Type 2.0 SNA node. Independent LU session types must use Type 2.1
SNA nodes.
ACTION: Change the node type of the SNA node to 2.1, or configure a
different SNA node for the session type.
21 MESSAGE: Path : APPC.SESSION.!.LULIST
There are no LU names configured for this path. (APPCVALERR 21)
CAUSE: You have configured a dependent LU session type with no local
dependent LUs.
ACTION: Configure as many dependent LUs as you will have sessions of
the session type configured. Dependent LUs are configured in the
APPC: Dependent LU List Data screen.
22 MESSAGE: Path : APPC.SESSION.!
Node “!” is not configured under the SNANODE screen.
(APPCVALERR 22)
CAUSE: You have configured a session type to use an unconfigured SNA
node.
ACTION: Configure the SNA node in the SNA Node Configuration
screen.
23 MESSAGE: Path : !
LU “!” is not configured under the SNANODE.! screen.
(APPCVALERR 23)
CAUSE: You have configured a session type to use a local LU that is not
configured on the SNA node you specified for the session type.
ACTION: Configure the local LU in the SNA Node Configuration: LU
Data screen for the SNA node used by the session type, or change the
local LU to one that is already configured.