APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

168 AppendixA
Messages
Warning Messages
Warning Messages
Warning messages may be returned by the APPC subsystem when the
node manager issues an APPCCONTROL command. These messages are
returned to the terminal from which the command is issued.
1201 MESSAGE: SESSION LIMIT EXCEEDED, REMAINING SESSION
IGNORED. (APPCWARN 1201)
CAUSE: The total session limit of the subsystem has been reached
before the end of the configuration file. Remaining session types are
initialized in the APPC Object with SESSION_LIMIT = 0.
ACTION: No action is necessary if you don't use those session types that
are not initialized in the APPC Object. Use the APPCONTROL SESSIONS
command to rearrange the session limit. Shut down the subsystem and
update the configuration file when necessary.
1202 MESSAGE: CATREAD FAILED. (APPCWARN 1202)
CAUSE: Detected non-zero result code during CATREAD call. Unable to
continue printing the startup messages.
ACTION: Make sure the subsystem is started up correctly. If this
problem occurs the next time the subsystem is started, call your
HP representative.
1203 MESSAGE: NO SESSION TYPES CONFIGURED FOR PARALLEL
SESSIONS. (APPCWARN 1203)
CAUSE: The APPCCONTROL STATUS command was issued with
STYPE=SNASVCMG to display the CNOS sessions. However, no session
types are configured for parallel sessions, so no CNOS sessions can be
displayed.
ACTION: No action required.
1204 MESSAGE: APPC INTERNAL STATE TRACING ALREADY ENABLED.
(APPCWARN 1204)
CAUSE: APPCCONTROL TRACEON command was issued when APPC
subsystem internal state tracing was already enabled.
ACTION: No action required.
1205 MESSAGE: APPC INTERNAL STATE TRACING ALREADY DISABLED.
(APPCWARN 1205)
CAUSE: An APPCCONTROL TRACEOFF command was issued when APPC
subsystem internal state tracing was already disabled
ACTION: No action required.