APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 167
Messages
Error Messages
1073 MESSAGE: APPC SUBSYSTEM PENDING ACTIVE. (APPCERR 1073)
CAUSE: The command issued cannot be executed because the APPC
subsystem is in the progress of starting up.
ACTION: Check the status of the APPC subsystem and reenter your
command when the subsystem is active. If problems still exist, call your
HP representative.
1074 MESSAGE: APPC SUBSYSTEM ALREADY ACTIVE. (APPCERR 1074)
CAUSE: The APPCCONTROL START command was issued (or the
APPCStart intrinsic was called) after the APPC subsystem had already
been activated.
ACTION: No action necessary.
1075 MESSAGE: APPC SUBSYSTEM SHUTTING DOWN. (APPCERR 1075)
CAUSE: An APPCCONTROL START or an APPCCONTROL SESSIONS
command was issued after initiation of subsystemn shutdown.
ACTION: Check the status of the subsystem and wait until the
subsystem has shut down completely. If the command entered was
APPCCONTROL START, re-enter the command. If the command entered
was APPCCONTROL SESSIONS, restart the subsystem with APPCCONTROL
START, and then reissue the APPCCONTROL SESSIONS command.
1076 MESSAGE: INVALID OR INACTIVE SESSION TYPE REQUESTED.
(APPCERR 1076)
CAUSE: The command issued cannot be executed because the requested
session type is not in ACTIVE state.
ACTION: Use the APPCCONTROL STATUS command to verify the state of
the session type. Use APPCCONTROL SESSIONS to activate the session
type if it is in a NO SESS state.