APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

116 Chapter5
Managing the APPC Subsystem
Managing APPC Sessions
In the following example, the APPCCONTROL STATUS command is issued
with the parameter STYPE=INDSESS2, so information is displayed for
only one session type. Session type INDSESS2 is an independent session
type with two active sessions. The identical TPIDs show that both
sessions are being used by one instance of the same TP; that is, one
instance of the TP is conducting two conversations simultaneously, over
two APPC sessions.
:APPCCONTROL STATUS;STYPE=INDSESS2
Internal Trace File : NMTC0020.PUB.SYS
Performance Tracing : ON
--------------------------------------------------
Number of Active Sessions for APPC Subsystem : 3
--------------------------------------------------
Session Type Information:
--------------------------------------
Independent LU Session Type : INDSESS2
--------------------------------------
Number of Active Sessions : 2
Number of Queued Session Requests : 0
Session Limits
Local LU SNA Node Remote LU Mode Maximum Current
-------- -------- ----------------- ------ ------- -------
INDLU2 SNANODE NET1.IBMLUA MODE1 8 2
Session ID LFSID State LU Type TP ID
---------- ----- -------- ------- -----
12 0103 1 ACTIVE PRI 1256
74 0104 1 ACTIVE PRI 1256