Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Chapter 5 75
Using NMMGR in Maintenance Mode
Maintenance Mode Commands
MAKESTREAM Creates a job stream used to perform network directory
or configuration file updates on remote nodes.
MERGEDIR Merges entries from another network directory or
configuration file into the current network directory.
NICONF Sets up paths to add or update NETXPORT NI
configurations.
OPENCONF Opens a nodal configuration file and makes it the current
configuration file.
OPENDIR Opens a network directory file and makes it the current
directory.
PAGECONF Sets the page number for multipage data screens.
PASSWORD Sets the password. Validates the NETXPORT subsystem
configuration. Changes the password to allow write
access on the OPEN screen.
PATHCONF Sets the current path in the current configuration file.
PURGECONF Deletes the subtrees of records from the configuration
file.
PURGELDEV Purges LDEVs from the DTC card.
PURGELU Purges LUs from the SNA node transport screen
PURGENI Purges a network interface from the configuration file
and performs cleanup.
PURGEVC Deletes a virtual circuit address key from the network
directory and the configuration file.
READALLCONF Reads all data from the current configuration record.
READCONF Reads selected data from the current configuration
record.
SUMMARYCONF Prints a report for one or more communications
subsystems.
UPDATECONF Updates the current path in the configuration file.
VALIDATECONF Validates subsystem configuration.
VERSIONCONF Checks whether the specified version number matches
NMMGR’s current version number.
WRITECONF Writes data to individual fields of the current path in the
configuration file.
Table 5-1 NMMGR Maintenance Mode Commands
Command Action