Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

248 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
ACTION: If an incorrect link name was entered, enter the correct link
name and try again. If the link name is correct but the link has not yet
been configured, enter the information for the link and press the
Save
Data key, then try again.
NMGRERR 262 MESSAGE: Must be a number from 0 to 5. (NMGRERR 262)
CAUSE: At the DTC Configuration screen, the user entered an invalid
character in the field specifying the card to be configured and pressed
the Config Card key.
ACTION: Enter the number of the card to be configured and press
Config
Card again. The number must be between 0 and 5 and must correspond
to the DTC slot number of the card being configured.
NMGRERR 263 MESSAGE: Data saved, but the home Network Interface does not
exist. (NMGRERR 263)
CAUSE: The user specified a nonexisting NI name as the home network
interface and saved the data on the screen.
ACTION: If an incorrect NI name was specified, correct the NI name and
press
Save Data again. If the NI name is correct but the NI has not yet
been configured, configure the NI. There is no need to reenter the
information on the current screen since it has already been saved.
NMGRERR 264 MESSAGE: Data saved, but the SNA does not exist. (NMGRERR 264)
CAUSE: The user specified a nonexisting SNA node and saved the data
on the screen.
ACTION: If an incorrect SNA node was specified, correct the SNA node
name and press
Save Data again. If the SNA node name is correct but
the SNA node has not yet been configured, configure the SNA node.
There is no need to reenter the information on the current screen since
it has already been saved.
NMGRERR 265 MESSAGE: This link name does not exist for this router NI.
(NMGRERR 265)
CAUSE: The user entered a nonexisting link name and pressed the
Link
Routing key.
ACTION: If an incorrect link name was specified, correct the link name
and try again. If link name is correct but the link has not yet been
configured, configure the link.
NMGRERR 266 MESSAGE: The path report for the node is full; no new address can
be added. (NMGRERR 266)
CAUSE: The user attempted to add an address to the network directory
for a node whose path report is already full. No additional addresses
can be added.
ACTION: Go to the Network Directory Data screen for the node and
delete some of the addresses assigned to the node name.