Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

Appendix A 241
NMS Error Messages
NMGR Error and Warning Messages
ACTION: Go to the validation screen and validate SNA/DS or type exit
again to leave the file unvalidated.
NMGRERR 141 MESSAGE: Subsystem(s) are not validated. Type ERR for more
information. (NMGRERR 141)
CAUSE: One or more of the subsystems in NMMGR have not been
validated.
ACTION: To see which subsystems have not been validated, type ERRORS
in the command line and press the
Enter key. Go to the validation screen
to validate the unvalidated subsystems or type exit again to leave the
file unvalidated.
NMGRERR 200 MESSAGE: Error in build statement table. (NMGRERR 200)
CAUSE: This is an internal NMMGR error. The number of statements in
an internal table does not match the number expected by NMMGR.
ACTION: Restore the file NMMGRCAT.PUB.SYS. Then run
NMMAINT.PUB.SYS to make sure the version of NMMGR is correct.
NMGRERR 201 MESSAGE: Internal error in Guided config scanner. (NMGRERR 201)
CAUSE: This is an internal guided configuration error caused by a
corrupt NMMGRCAT.PUB.SYS file.
ACTION: Restore NMMGRCAT and retry. If this fails see “Submitting a
CR” at the beginning of this appendix.
NMGRERR 202 MESSAGE: Aux NCONF file already open. (NMGRERR 202)
CAUSE: This is an internal guided configuration error caused when
more than one NMCONF file is opened by the guided configuration
open statement.
ACTION: See “Submitting a CR” at the beginning of this appendix.
NMGRERR 203 MESSAGE: Cannot open source, destination, or Aux NCONF file.
(NMGRERR 203)
CAUSE: This is caused when the source/destination file or the file
NMAUX1.PUB.SYS is either missing, is the wrong version, is locked for
exclusive access, or was corrupted during a subtree copy.
ACTION: If doing a subtree copy, check to see that the source and
destination files really exist. If performing a guided configuration task,
copy NMAUX1.PUB.SYS from backup tape, and run NMMAINT.PUB.SYS to
make sure that you have the correct version.
NMGRERR 204 MESSAGE: Aux NCONF file not opened. (NMGRERR 204)
CAUSE: This is an internal guided configuration error caused when data
is copied from the auxiliary file to the user file and the auxiliary file was
not opened.
ACTION: See “Submitting a CR” at the beginning of this appendix.