Using the Node Management Services (NMS) Utilities (MPE/iX 7.0, 7.5)

132 Chapter6

NMMAINT

Running NMMAINT

To run NMMAINT, enter the command:

:RUN NMMAINT.PUB.SYS

NMMAINT responds with the following:

NMS Maintenance Utility 32099-11018v.uu.ff (C) Hewlett Packard Co. 1984

NMMAINT then lists the version identiﬁcation numbers for each

software module and information for each subsystem. As shown in the

example below, the NMMAINT utility displays version information for

the subsystems of the products actually installed on your system. The

node management services, link services, and network transport

subsystems are displayed if an NS 3000/iX link product is installed.

The Network Services subsystem is displayed if the NS 3000/iX services

product is installed. The SNA Transport, SNA NRJE, RJE, SNA DHCF,

APPC, HP SNADS, SNA/X.25, NS Over SNA, HP SNADS, and SNA IMF

subsystems are displayed if the appropriate HP-to-IBM data

communications products are installed on your system. PCI LAPB, PCI

SDLC, LINK COMMON, PCI 100BASE-T LINK subsystems are displayed if

appropriate PCI link products are installed on your system.

NMMAINT Output

This example of NMMAINT output shows a system with NS 3000/iX

services and an IEEE 802.3 link installed. (The IPCVERSION module is

port software. This is not part of the Network IPC user service, nor does

it form a subsystem, but its individual version ID number is displayed

by NMMAINT for your information.)

Notice that version ID numbers include version, update, ﬁx levels, and

an internal ﬁx level in the format

vuuffiii

.ForNMVERS00, the version

ID number is B0011001. B is the version level, the next two digits 00

represent the update level, and the next two digits 11 are the ﬁx level.

The remaining numbers, 001, show the internal ﬁx level, which is used

only within Hewlett-Packard.

NOTE

The version numbers shown in this example are not intended to be the

same as the version numbers of your software.