UPS Utility Manual

Example #2
- Using UPSCNFGB.PUB.SYS
The next example shows the selection of
a new UPS Monitor configuration file, UPSCNFGB.PUB.SYS, in which the
powerfail message routing option is set to "console only". Again, the STATUS command shows the results.
UPSUTIL: Command > newconfig
------------------------------------------------------------------------------
Begin SET NEW CONFIG FILE UPS Monitor operation
Enter the file name of the new configuration file (file.group.account)
New config file name? upscnfgb.pub.sys
SET NEW CONFIG FILE UPS Monitor operation successfully initiated.
End SET NEW CONFIG FILE UPS Monitor operation
------------------------------------------------------------------------------
UPSUTIL: Command > status
------------------------------------------------------------------------------
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS:
UPS Monitor Operating State : Running (PIN = 78)
UPS Monitor Version Number : 9 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : Console only. 3 UPS Devices Allocated
Configuration File Name : UPSCNFGB.PUB.SYS ( Config File Ok )
Powerfail Command File Name : $null ( Pfail Cmd File Ok )
Powerfail Command File Parms: none
Powerfail Grace Period (secs: 0
Powerfail Grace Timer : Not Running.
Powerfail Command File : Not Running.
Action on UPS Low Battery
: Keep Running
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
------------------------------------------------------------------------------
UPSUTIL: Command >
Page
24
of
48
UPS Utility
7/18/2008
http://jazz.external.hp.com/papers/upsutil.htm