UPS Utility Manual

The first example shows a NEWCONFIG command being used to set the configuration using
the default
UPSCNFIG.PUB.SYS configuration file.
A STATUS command following the NEWCONFIG command reports the results
of using UPSCNFIG.PUB.SYS.
-----------------------------------------------------------------------------
UPSUTIL: Command > newconfig
------------------------------------------------------------------------------
Begin SET NEW CONFIG FILE UPS Monitor operation
Enter the file name of the new configuration file (file.group.account)
New config file name? upscnfig.pub.sys
SET NEW CONFIG FILE UPS Monitor operation successfully initiated.
End SET NEW CONFIG FILE UPS Monitor operation
------------------------------------------------------------------------------
UPSUTIL: Command > status
------------------------------------------------------------------------------
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS:
UPS Monitor Operating State : Running (PIN = 78)
UPS Monitor Version Number : 9 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : All terminals. 3 UPS Devices Allocated
Configuration File Name : UPSCNFIG.PUB.SYS ( Config File Ok )
Powerfail Command File Name : $null ( Pfail Cmd File Ok )
Powerfail Command File Parms: none
Powerfail Grace Period (secs: 0
Powerfail Grace Timer : Not Running.
Powerfail Command File : Not Running.
Action on UPS Low Battery
: Keep Running
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
-----------------------------------------------------------------------------
UPSUTIL: Command >
Page
23
of
48
UPS Utility
7/18/2008
http://jazz.external.hp.com/papers/upsutil.htm