Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Messages
Appendix A
93
For level 2, you need SM or DI or OP capability.
CAUSE: You do not have the correct user capabilities to do this function.
ACTION: Logon as a user with the correct capabilities for the functions you wish to use.
Refer to Chapter 4, “TermDSM Commands,” for the security level of each command and
subcommand.
(TDSM 93) MESSAGE: TermDSM could not open the DTC manager, so the DTC dump could not be
obtained. (TDSM 93)
CAUSE: Internal error, unless another TermDSM was being run against that same DTC
and you chose not to override the other user. There is no error in this case.
ACTION: Contact your HP support representative (if it is an internal error).
(TDSM 110) MESSAGE: You can’t test your own port. Please run TermDSM from another port.
(TDSM 110)
CAUSE: Double check the numbers entered. If you wish to test a port, you cannot be
logged on to that port; the operation will abort your session and you will be unable to
obtain the results of the test.
ACTION: If you want to test the port to which you are logged on, move to another port or
the system console to run TermDSM.
(TDSM 113) MESSAGE: Please put a loopback hood on the port, before answering the “How may
times?” question. (TDSM 113)
CAUSE: A loopback hood must be in place before the diagnostic is run.
ACTION: Place loopback hood on the port and continue.
(TDSM 114) MESSAGE: Please connect and make ready (power on, remote mode, etc.) a
supported terminal, before answering the 'How many times?' question. (TDSM 114)
CAUSE: The hardware must be present before the diagnostic is run.
ACTION: Make a supported terminal ready and continue.
(TDSM 115) MESSAGE: Please connect and make ready (power on, remote mode, etc.) a
supported printer (or terminal), before answering the “How many times?” message.
(TDSM 115)
CAUSE: The hardware must be present before the diagnostic is run.
ACTION: Make a supported printer (or terminal) ready and continue.
(TDSM 118) MESSAGE: You can’t reprogram EEPROM on your own DTC. Please run TermDSM
from another DTC or from the console. (TDSM 118)
CAUSE: Your own session is on this DTC. If you wish to reprogram EEPROM, you can’t
be logged onto that DTC; the operation will abort your session and you will be unable to
obtain the results.
ACTION: Move to a port on a different DTC or to the system console to run TermDSM.
(TDSM 121) MESSAGE: Warning: The LDM dump is suspect. Consecutive dumps did not match.
(TDSM 121)
CAUSE: This message is written to dump files and never appears as an error message to
a user. There was activity during the dump process, so part of the dump relating to the
Logical Device Manager might be inconsistent with the rest of the dump.
ACTION: Submit the dump to your HP support representative.