Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Messages
Appendix A
92
(TDSM 71) MESSAGE: There are more DTCs on your system than TermDSM can reference. Here
are the ones TermDSM can reference. (TDSM 71)
CAUSE: You are using more than 120 DTCs on the system. You will not be able to perform
any TermDSM functions on any DTCs that are not listed in this message.
ACTION: Contact your HP support representative.
(TDSM 80) MESSAGE: You can’t reset your own port or ldev. Please run TermDSM from a different
port or ldev to do this. (TDSM 80)
CAUSE: Verify the ldev numbers entered. If you want to reset a port, you cannot be
logged on to that port; the operation will abort your session.
ACTION: If you want to reset the port you are using, move to another port or the system
console to run TermDSM.
(TDSM 81) MESSAGE: That ldev is unknown (not configured). Please check the ldev number, or
use reset port. (TDSM 81)
CAUSE: Although a number was entered in a range that could be an ldev number, that
number is not configured on the system.
ACTION: Verify the ldev number by entering the SHOWJOB command. You can also reset
ports by using the POrt subcommand (which uses the physical address instead of the
ldev number).
(TDSM 82) MESSAGE: You must have high (1) or medium (2) security to do resets, and high (1)
security to reset DTCs. (TDSM 82)
For level 1, you need SM or DI capability.
For level 2, you need SM or DI or OP capability.
CAUSE: You do not have the correct user capabilities to do this function.
ACTION: Logon as a user with the correct capabilities for the functions you wish to use.
Refer to Chapter 4, “TermDSM Commands,” for the security level of each command and
subcommand.
(TDSM 83) MESSAGE:The specified local X.25 link appears to have just shut down. Please try
again or do a new “Map” command. (TDSM 83)
CAUSE:
The link requested is configured on the local system and TermDSM
attempted to get the Connection list from the local system for the selected link
but The link is no longer up
.
ACTION:
Reenter the MAP command and verify if the selected link is displayed in
the map table.Check that the correct entry number was entered
.
(TDSM 84) MESSAGE:The specified remote X.25 link was not accessible. (TDSM 84)
CAUSE:
TermDSM attempted to get the Connection list from the remote system
for the selected link but the remote system did not return any data to the local
system.
ACTION: Verify that the X.25 liink on the remote system is started and retry the
MAP and then the LIST command.
(TDSM 86) MESSAGE: You must have high (1) or medium (2) security to test ports, and high (1)
security to selftest DTCs. (TDSM 82)
For level 1, you need SM or DI capability.