Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
X25SITE
Chapter 4
83
X25SITE
The X.25 Site Management function displays information on X.25
system-to-system connections between MPE/iX systems.
.
Security level: 2.
Syntax
X[25site]
Description
The connection information that can be displayed covers three areas.
• Information on the DTCs managed by the MPE/iX system where TermDSM is
running
• Information on the an X.25 link between the DTC and the PSN
• Information about the second system. This system is called the remote system in the
displayed information
The information is displayed in three tables.
• The first table lists all the system-to-system links that are active on all the DTC that
the system is managing.
• The second table lists all the connections that are established through one of the
selected links.
• The third display presents detailed information on one connection selected from the
list of connections.
The X.25 Site Managment subsection has the following subcommands:
(X.25 Site Management)
Map - Display the X.25 Active Site Network
List # - Display the Connectivity list for selected Network
Status # - Display the VC status for selected connection.
(carriage return to exit) ?
When the X25SITE command is first entered, only the MAP subcommand is available.
When the X.25 Active Site Network table is completed, then you can enter the MAP
command to redisplay the Active Network map or the LIST command to select one of the
links and display the Connectivity List. Once the LIST command is entered, then you
can enter the STATUS command to display informtion about a selected Virtual
Connection (or LCI number).
[CTRL]-Y
can be used during execution of any of the above subcommands to stop the
output.
The following sections describe the subcommands.