Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
T[RACE]
Chapter 4
82
(carriage return to exit) ?
Enter the link name of the X.25 link as configured in NMMGR. The link name may be up
to eight (8) ASCII characters.
You will then see the following prompt at the terminal:
(filter)
HDr (Header only)
FUll (Full Packet)
(carriage return to exit) ?
Enter HDr if you want only header information (including TCP/IP headers) included in
the trace.
Enter FUll if you want full packet information included in the trace.
You will then be prompted to enter a trace file name, as follows:
(Filename)
Please enter a filename for the X.25 trace or press carriage
return to use the default (TRACE.PUB.SYS). Trace file will
be kept in PUB.SYS.
(carriage return to accept default) ?
T[RACE] X2[5] TRACEOF[F]
Turns off a trace for a VC, level 2, or level 3 on an X.25 card.
Security level: 2.
Syntax
TRACEOF[F]
Description
Turns off the trace activated through a previous TRACEON command. Since only one trace
can be active at a time, this command does not require any parameters.