Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
T[RACE]
Chapter 4
79
Parameters
dtcnum
Number of the DTC that contains the asynchronous board with a port
that is being traced. This is the number TermDSM associates with this
DTC.
boardnum
Number of the asynchronous board that contains the port being traced.
Description
TRACEOFF turns off extended trace on a port. You must turn off tracing on a port before
starting extended tracing on another port on the same board.
After TRACEOFF is issued, the trace information will be overwritten. In order to keep the
trace information, do a DUMP PORT before the TRACEOFF subcommand.
T[RACE] TI[O] TRACES[HOW]
Lists all the ports on the specified DTC 72MX that currently have extended tracing on.
Security level: 2.
Syntax
TRACES[HOW] dtcnum
Parameter
dtcnum
Number of the DTC 72MX that has extended tracing on for one or more
of its asynchronous processor boards. This is the number TermDSM
associates with this DTC.
T[RACE] X2[5]
Specifies tracing for a particular VC on an X.25 card on a DTC 16, DTC 48, or DTC
72MX.
Security level: 2.
Syntax
T[RACE] X2[5]
Description
After the command is entered, the following prompt is printed on the terminal:
(X25 trace)
TRACEON #, #, #
TRACEOFf
(carriage return to exit) ?
TRACEON and TRACEOFF are subcommands that can be entered with the TRACE X25
command. The following pages describes these options.