Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
MULTI
Chapter 4
66
Current operation START. Selected Modules X.25 [X] PAD [X]
STARt #,# (X.25,PAD)
STOp #,# (X.25,PAD)
Dtc # List of DTCs
(carriage return to exit) ?dt 1,2
DTC
After the operation and protocols are selected this command is used to initiate the
operation on a set of selected DTCs.
Syntax
D[tc] dtcnums
Parameters
D[tc] The DTC number TermDSM associates with a particular DTC. The
DTC command lists each DTC with its assigned DTC number.
You may specify multiple DTCs with one DTC command. The first
command below sends the start or stop command to DTC 3, 5 and 9.
The second command sends the start or stop command to DTCs 4
through 15 inclusive.
DTC 3, 5, 9
DTC 4/15
Description
After the DTC command is entered, the operation will be attempted on all the selected
cards and DTCs. The following is an example of the status display that is printed on the
terminal.
Example for Start operation:
(carriage return to exit) ?dt 1,2
DTC 1 Board 2 :Start X.25 Sucessful, start PAD sucessful.
DTC 2 Board 2 :Start X.25 Sucessful, start PAD sucessful.
DTC 2 Board 3 :Start X.25 Sucessful, start PAD sucessful.
(multiple operations)
Current operation START. Selected Modules X.25 [X] PAD [X]
STARt #,# (X.25,PAD)
STOp #,# (X.25,PAD)
Dtc # List of DTCs
(carriage return to exit) ?