Troubleshooting Terminal, Printer, and Serial Device Connections - Edition 5 (32022-90058)

TermDSM Commands
MULTI
Chapter 4
65
MULTI
This command accesses the subcommands that allow you to start or stop the X.25 or
PAD protocols on multiple DTCs and multiple X.25 cards.
Security level: 1.
Syntax
M[ulti]
Description
After the MULTI command is entered, the following prompt is printed on the terminal:
(multiple operations)
Current operation NONE. Selected Modules X.25 [ ] PAD [ ]
STARt #,# (X.25,PAD)
STOp #,# (X.25,PAD)
Dtc # List of DTCs
(carriage return to exit) ?
When the submenu is first displayed, the selected operation is NONE. You must first
enter the START or STOP command and specify either 'Y' or 'N' for both protocols. Once
the current operation is set, then enter the DTC command with the numbers of the
desired DTCs. The three subcommands are described in the following sections.
START or STOP
These subcommands select whether the operation to be performed on the DTC will be to
start or stop the selected protocols.
Syntax
STAR[t]
x25, pad
STO[p] x25, pad
Parameters
x.25
If this parameter is 'Y' then the X.25 protocol is selected, otherwise
enter 'N' to unselect the protocol.
pad
If this parameter is 'Y' then the PAD protocol is selected, otherwise
enter 'N' to unselect the protocol.
Description
After the START or STOP command is entered, the current operation changes to the one
specified, and an 'X' is displayed for the selected protocols.
Example for Start operation:
(carriage return to exit) ?star y y
(multiple operations)