Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

99
A TermDSM Messages
MESSAGE: You have entered an unknown or incorrect command.
Please try again. (TDSM 15)
(TDSM 15) CAUSE: You have entered something that is not a TermDSM command
or a command that is not valid in this context.
ACTION: Commands that are valid at this time are listed in the
prompt. Please try again. Type HELP or refer to Chapter 4, “TermDSM
Commands,” for more information.
MESSAGE: TermDSM has compiled without $partial eval$ in effect. It
cannot continue. This problem must be fixed at the factory. (TDSM 16)
(TDSM 16) CAUSE: Internal error.
ACTION: Contact your Hewlett-Packard support representative.
MESSAGE: Your security level (3) is too low to use TermDSM. Please
log on with level 0, 1, or 2 security. (TDSM 17)
For level 0, you need SM capability.
For level 1, you need SM or DI capability.
For level 2, you need SM or DI or OP capability.
(TDSM 17) CAUSE: You do not have the correct user capabilities to use TermDSM.
ACTION: Logon as a user with the correct capabilities for the TermDSM
functions you wish to use. Refer to Chapter 4, “TermDSM Commands,”
for the security levels of each command and subcommand.
MESSAGE: You have entered a bad port number. Port numbers range
from 0 to 23. (TDSM 18)
(TDSM 18) CAUSE: You have entered an invalid port number. Port numbers range
from 0 to 7 for DTC 16 and DTC 48, from 0 to 15 for DTC 16iX/16MX,
and from 0 to 23 for DTC 72MX.
ACTION: The port number was not entered or is unrecognizable.
MESSAGE: The port number is missing or invalid. Port numbers
range from 0 to 23. (TDSM 19)
(TDSM 19) CAUSE: Internal error.
ACTION: Enter a valid port number. Refer to the prompt or Chapter 4,
“TermDSM Commands,” for syntax.
MESSAGE: You have entered a bad ldev number. Ldev numbers are
positive integers. (TDSM 20)
(TDSM 20) CAUSE: The value that you entered as a logical device number is not a
number greater than zero.