Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

96 Chapter 4
TermDSM Commands
T[RACE] X2[5] TRACEON
Enter PAd to trace PAD VCs only, enter SYs to trace system-to-system
VCs only, enter All to trace both PAD and system-to-system VCs.
You will then be asked to enter the link name, as follows:
(linkname)
Please enter the linkname for level 3 trace
(carriage return to exit) ?
Enter the link name of the X.25 link as configured in NMMGR. The link
name may be up to eight (8) ASCII characters.
You will then see the following prompt at the terminal:
(filter)
HDr (Header only)
FUll (Full Packet)
(carriage return to exit) ?
Enter HDr if you want only header information (including TCP/IP
headers) included in the trace.
Enter FUll if you want full packet information included in the trace.
You will then be prompted to enter a trace file name, as follows:
(Filename)
Please enter a filename for the X.25 trace or press carriage
return to use the default (TRACE.PUB.SYS). Trace file will
be kept in PUB.SYS.
(carriage return to accept default) ?