Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

Chapter 4 77
TermDSM Commands
R[ESET] PO[RT]
R[ESET] PO[RT]
Clears the software associated with a particular port so that the
associated device can be used again.Security level: 2.
Syntax
PO[RT] dtcnum,cardnum,portnum
Parameters
dtcnum Number of the DTC to which the device is connected.
This is the number TermDSM associates with this
DTC.
cardnum Number of the interface card within the DTC to which
the device is connected. The cards are numbered from
zero beginning at the bottom of the DTC as you face the
back of the DTC.
portnum Number of the port on the interface card. The ports are
numbered from zero beginning at the left of the board
as you face the back of the DTC.
Description
This subcommand resets the ldev number that is currently associated
with the port. It also aborts any session or job that is running on the
port.
When it is complete, the reset prompt will be displayed and you can
then enter another RESET subcommand.