Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)
112 Appendix A
TermDSM Messages
ACTION: Wait for the download, or upload/download, to complete (as
shown by the console messages). Verify then that the DTC is
operational. If not, contact your HP support representative.
MESSAGE: The DTC requested that it be dumped during the
operation. (TDSM 249)
(TDSM 249) CAUSE: The DTC detected an internal error at the same time you were
trying to access it through TermDSM.
ACTION: Wait for the download, or upload/download, to complete (as
shown by the console messages). Then verify if the DTC is operational.
If not, contact your HP support representative.
MESSAGE: DTC and host RMP versions are incompatible. (TDSM 250)
(TDSM 250) CAUSE: Incompatibilities were found between subsystem software on
the HP 3000 and subsystem software on the DTC.
ACTION: Contact your HP support representative.
MESSAGE: Bad RMP packet received from DTC. (TDSM 251)
(TDSM 251) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: Could not open the download or dump file. (TDSM 252)
(TDSM 252) CAUSE: Files pertaining to this operation cannot be accessed.
ACTION: If this is a dump, verify that sufficient disk space exists to
create the dump file. Approximately 2200 sectors of disk space is
required. If enough disk space is available (or if you were not trying to
perform a dump operation), contact your HP support representative.
MESSAGE: Unable to get a system timer. (TDSM 253)
(TDSM 253) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: Dump overflow: DTC sent more data than expected.
(TDSM 255)
(TDSM 255) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: Dump overflow: DTC sent more data than expected.
(TDSM 255)
(TDSM 255) CAUSE: Internal error.
ACTION: Contact your HP support representative.
MESSAGE: Bad NMP error code received. (TDSM 260)
(TDSM 260) CAUSE: Unknown error reported by the Distributed Terminal
Subsystem to TermDSM.