System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 3
System Startup Functions
Dumping System Memory and Secondary Storage
84
[{ ;SINGLE-DISC [{ ;SINGLE-USER
;MULTI-DISC }] ;MULTI-USER }]
[{ ;SYSSTART
;NOSYSSTART }]
When the START option of the UPDATE utility is selected, the remaining options are available.
UPDATE [{ ;CONFIG [{ ;START;
;NOCONFIG }] ;NOSTART } [options] ]
where options are: [;LOGON=acct][GROUP=cgn]
[{ ;SINGLE-DISC [{ ;SINGLE-USER
;MULTI-DISC }] ;MULTI-USER }]
[{ ;SYSSTART
;NOSYSSTART }]
When the START option of the INSTALL utility is selected, the remaining options are available.
INSTALL [{ ;START
;NOSTART } [options] ]
where options are: [;GROUP=cgn][LOGON=acct]
[{ ;SINGLE-DISC [{ ;SINGLE-USER
;MULTI-DISC }] ;MULTI-USER }]
[{ ;SYSSTART
;NOSYSSTART }]
When the START option of the DUMP utility is selected, the remaining options are available.
DUMP [ SUBSET= { ALL [{ ;START
MEMORY }] ;NOSTART }[options] ]
Where options are:
[{ ;RECOVERY [{ ;SINGLE-DISC
;NORECOVERY }] ;MULTI-DISC }]
[{ ;SINGLE-USER [{ ;SYSSTART
;MULTI-USER }] ;NOSYSSTART }]
All available options are defined in Table 3-3.
Table 3-3 Utility Options
Options Functions
CONFIG or NOCONFIG
Default: NOCONFIG
During an UPDATE, this option specifies whether or not the configuration
data files on disk (CONFIG group), are replaced by those on tape
(CONFIG). If this option is not specified, the default is NOCONFIG