System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 3
System Startup Functions
Starting the System
58
ALLOCATE COBOLII.PUB.SYS
LIMIT 8,16
JOBFENCE 6
OUTFENCE 6
OUTFENCE 12;LDEV=14
FILE T;DEV=TAPE
***
WARMSTART
STREAMS 10
ALLOW @.@;COMMANDS=REPLY
ALLOCATE COBOLII.PUB.SYS
LIMIT 8,16
JOBFENCE 6
OUTFENCE 6
OUTFENCE 12;LDEV=14
FILE T;DEV=TAPE
***
COOLSTART
STREAMS 10
ALLOW @.@;COMMANDS=REPLY
ALLOCATE COBOLII.PUB.SYS
LIMIT 8,16
JOBFENCE 6
OUTFENCE 6
OUTFENCE 12;LDEV=14
FILE T;DEV=TAPE
***
UPDATE
LIMIT 1,1
JOBFENCE 14
OUTFENCE 14
STARTSESS 20;MANAGER.SYS/PASSWORD;HIPRI;NOWAIT
***
RELOAD
LIMIT 1,1
JOBFENCE 14
OUTFENCE 14
STARTSESS 20;MANAGER.SYS/PASSWORD;HIPRI;NOWAIT
The STARTUP module is executed whenever the SYSSTART file is accessed. Place commands and parameters
specific to an operation under the appropriate heading. If, for instance, you do not wish users to be able to log
on immediately following an UPDATE (START) or INSTALL (START), insert commands in the update and install
modules to limit the jobs and sessions and raise the jobfence. Table 3-2 describes how each module is
executed.
The SYSSTART file must be created by MANAGER.SYS and needs to reside on LDEV 1 to function properly. Once
the file is created, use the following commands to copy the file to the appropriate location:
Table 3-2 Execution of SYSSTART File Modules
Boot Utility Used SYSSTART Module Executed
ANY startup
START (RECOVERY) warmstart
START (NORECOVERY) coolstart
UPDATE (START) update
INSTALL (START) reload