System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 3
System Startup Functions
Activating and Deactivating Autoboot and Autosearch Functions
52
Primary boot path is 0/0/2/0.6.0.0.0.0.0
Primary boot path is (hex) 0/0/2/0.6.0.0.0.0.0
Alternate boot path is 0/0/1/0.6.0.0.0.0.0
Alternate boot path is (hex) 0/0/1/0.6.0.0.0.0.0
System console path is 0/0/4/0.0.0.0.0.0.0
System console path is (hex) 0/0/4/0.0.0.0.0.0.0
ISL>
Setting Fastsize
If fastsize is set to the wrong value, you cannot do installs or updates. The only value that is acceptable is “F. ”
If you try to do an update or install with fastsize set to the wrong value, you will receive an error message
that reads UTILITY REQUIRES MORE MEMORY THAN IS CONFIGURED.
Consider the following example.
ISL> DISPLAY
Fastsize value is 00000003
.
.
.
This fastsize value is invalid. You must reset it to “F”; therefore, at the ISL prompt, enter Fastsize F, as in
the following example.
ISL> FASTSIZE F
If you changed the value of fastsize, you must reset the system for the new value to take effect. For more
information on resetting the system, refer to Chapter 2, “Initiating System Activity.”
Listing Autoboot File Contents
To list the contents of the current autoboot file, enter either LISTAUTOFL or LSAUTOFL at the ISL prompt:
ISL> LISTAUTOFL