System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 2
Initiating System Activity
System Startup Procedure
43
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
SERvice menu Displays service commands
DIsplay Redisplay the current menu
HElp [<menu>|<command>] Display help for menu or command
RESET Restart the system
----
Main Menu: Enter command or menu > bo
Interact with IPL (Y, N, or Cancel)?> y
Booting...
Boot IO Dependent Code (IODC) revision 1
SOFT Booted.
MMSAVE Version 2.5
DUMPAREA protected, proceeding to ISL without memsave
ISL loaded
ISL Revision A.00.43 Apr 12, 2000
ISL> start recovery
MPE/iX launch facility
Scanning PCI BUS 0 ++*..++..........................
Scanning PCI BUS 8 ................................
Scanning PCI BUS 10 *................................
Scanning PCI BUS 20 *................................
Scanning PCI BUS 28 +...............................
Scanning PCI BUS 40 ................................
Scanning PCI BUS 50 ................................
Scanning PCI BUS 60 *................................
Scanning PCI BUS 80 ................................
Scanning PCI BUS 90 ................................
Scanning PCI BUS A0 ................................
Scanning PCI BUS C0 +...............................
Scanning PCI BUS D0 ................................
Scanning PCI BUS E0 ................................
Initialize_genesis - Ver bld1: <<pci 2.1601>>
WED, NOV 15, 2000, 11:45:08 AM (y/n)? y
Initialize_genesis = Ready to configure I/O
[CDM]8 8 0 18
NOTE Currently there is no autoexecute file available; therefore, you must ignore the statement
Cannot find an auto-execute file. AUTOBOOT ABORTED. This does not present any
problems; just continue with the START command in ISL.