System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 2
Initiating System Activity
The Booting Process
38
Booting...
Boot IO Dependent Code (IODC) revision 1
SOFT Booted.
In this example, the system halts at ISL and then waits for the operator to issue an ISL command. For more
information on ISL and ISL utilities, refer to Chapter 3, “System Startup Functions.”
Bypassing the Disabled Autoboot Setting
Answering NO to the prompt Interact with IPL (Y or N)? causes the system to ignore a disabled autoboot
flag setting and attempt to autoboot.
Example 2-10 demonstrates bypassing a current disabled autoboot flag setting in order to autoboot.
Example 2-8 Bypassing the Disabled Autoboot Setting When Booting a System
GSP> tc
TC
Execution of this command irrecoverably halts all system processing and
I/O activity and restarts the computer system.
Type Y to confirm your intention to restart the system: (Y/[N]) y
y
-> SPU hardware was successfully reset.
GSP Host Name: csyprel18(csysas18)
GSP>
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH OFF ON ON
platform config 626F
processor test 1142
processor test 1100
. . .
platform test 612A
I/O config 8238
*****************************************