System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 2
Initiating System Activity
Resetting the System
24
Example 2-2 Resetting an N class System Using AP/GSP Commands
Autoboot Enabled
:<ctl-B>
GSP Host Name: csyprel18(csysas18)
GSP> tc
TC
Execution of this command irrecoverably halts all system processing and
I/O activity and restarts the computer system.
Type Y to confirm your intention to restart the system: (Y/[N]) y
y
-> SPU hardware was successfully reset.
GSP Host Name: csyprel18(csysas18)
GSP>
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH OFF ON ON
platform config 626F
processor test 1142
processor test 1100
processor test 1100
. . . .
processor test 1110
processor INIT 1701
processor test 1110
processor test 1142
processor test 1142
memory config 7280
memory test 71A8
memory test 71A8
. . . .
memory test 71A8
memory config 7280