System Startup, Configuration, and Shutdown Reference Manual (32650-90907)

Chapter 2
Initiating System Activity
Resetting the System
23
1 540 MHz Active Functional 512 KB 1 MB
3 Unknown Stopped:Deconfigured Unknown 512 KB 1 MB
Central Bus Speed (in MHz) : 133
Available Memory : 2097152 KB
Good Memory Required : Not initialized. Defaults to 32 MB.
Primary boot path: 0/0/2/0.6
Alternate boot path: 0/12/0/0.2
Console path: 0/0/4/0.0
Keyboard path: 0/0/4/0.0
---- Main Menu-------------------------------------------------------
Command Description
------- -----------
BOot [PRI|ALT|<path>] Boot from specified path
PAth [PRI|ALT|CON|KEY] [<path>] Display or modify a path
SEArch [DIsplay|IPL] [<path>] Search for boot devices
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
SERvice menu Displays service commands
DeBug menu Displays debug commands
MFG menu Displays manufacturing commands
DIsplay Redisplay the current menu
HElp [<menu>|<command>] Display help for menu or command
RESET Restart the system
----
Main Menu: Enter command or menu >
Answering NO to the boot path prompt initiates other prompts that query for the proper path to the boot
device. If you answer YES to the primary path prompt, the system displays additional messages as it boots the
processor and operating system.
Example 2-2 demonstrates a soft reset of the system with autoboot enabled, using console and AP/GSP
commands for a N class system. The reset screen may contain a different boot path display and additional
information, depending on the system you are using.
NOTE If you have a 99X system, you must transfer to the service processor before you reset the
system: CM> SP
If you have a 9X8LX or 9X8RX system, you need to type BO to boot the system from the
primary path.