Manualshelf

System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

ManualsBrandsHP ManualsSoftwareMPE/iX 7.0 Operating System
241242243244245246247248249250
Appendix H 243
Using the Guardian Service Processor (GSP)
Configuring the GSP
Remote Console Serial Port Modem Transmit Configuration Strings: Enabled
Remote Console Serial Port Modem Presence: always connected
Do you want to modify the Local Console Serial Port settings? (Y/[N]) n
n
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N]) n
n
GSP Host Name: <name>
GSP>
GSP LAN configuration (LC)
This commnd modifies the GSP LAN/Console configuration.These parameters must be set
to allow access to the GSP via the GSP LAN/Console port. This command sets the
following:
• The IP address
• The host name displayed at the GSP prompts,
• The Subnet mask to be used by this node,
• The address of the gateway node for this network.
Display a list of GSP connected users (WHO)
This command displays the login name of the connected console client users and the port
on which they are connected. For the LAN console clients the remote IP address is also
displayed.
There is always one user listed for the local serial port. This is a default user name ("local
user") if the local console client user didn't originate the GSP Command Interface session.
If the local console operator typed CTRL-B, then the login name that the local operator
typed is displayed instead.
SEE ALSO: TE (TEll)
Security Options & access control (SO)
This command is used to modify the security parameters of the GSP. These include user
accounts, login timeouts, allowed password faults, etc. Most of the parameters are
familiar; the following require some extra explanation:
Dial-Back: If configured, when the user accesses the GSP via the modem port, the GSP
will hang up and dial the user back. This will not work if "Modem Presence" is set to "not
always connected" in the CA command.
Mode: Single/Multiple. If the mode is Single, the State will be changed to disabled after
the first login.
User’s State: Enabled/Disabled. A disabled user's login will not be accepted.
(ADMINISTRATOR level command.)