System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

Appendix E 215
Verifying Attached Devices
Displaying Configured Devices
3. Once the system issues the final shutdown message:
Shutdown of operating system complete. (Shut 6)
Enter:
:CTRL B
CM> SP
Reset messages appear at the console while the system runs its self-test.
If autoboot is enabled on your system, interrupt it so that you receive the ISL prompt
(ISL>). Refer to Chapter 3 , “System Startup Functions,” for information on
interrupting an autoboot sequence.
4. Type the following to run ODE:
ISL>ODE
5. Initiate the mapper2 module:
ISL>RUN mapper2
mapper2 displays the current configuration (see Example E-1 for an example display).
Example E-1. Mapper2
Main Menu: Enter command or menu > bo pri
Interact with IPL (Y, N, or Cancel)?> yy
Booting...
Boot IO Dependent Code (IODC) revision 1
HARD Booted.
MMSAVE Version 2.5
DUMPAREA found, save main memory to disc
ISL loaded
ISL Revision A.00.43 Apr 12, 2000
ISL> ode
***************************************************************************
****** ******